欢迎访问《林产化学与工业》,

林产化学与工业 ›› 2020, Vol. 40 ›› Issue (1): 120-128.doi: 10.3969/j.issn.0253-2417.2020.01.017

• 研究报告 • 上一篇    

落叶松基复合材料SiO2@C的制备及其对染料的吸附行为研究

张玉杰,孔凡功,郭留柱,刘小克,赵鑫*()   

  1. 齐鲁工业大学(山东省科学院) 生物基材料与绿色造纸国家重点实验室, 山东 济南 250353
  • 收稿日期:2019-07-16 出版日期:2020-02-28 发布日期:2020-03-06
  • 通讯作者: 赵鑫 E-mail:zhaoxin_zixi@126.com
  • 作者简介:张玉杰(1995-),男,内蒙古赤峰人,硕士生,主要从事生物质基炭材料的制备及吸附和电化学应用研究工作
  • 基金资助:
    国家自然科学基金资助项目(31800499);国家自然科学基金资助项目(31600472)

Preparation and Adsorption Behavior Study of Larch-based SiO2@C Composites for Dyes

Yujie ZHANG,Fangong KONG,Liuzhu GUO,Xiaoke LIU,Xin ZHAO*()   

  1. Qilu University of Technology, Shandong Academy of Sciences, State Key Laboratory of Biobased Material and Green Papermaking, Jinan 250353, China
  • Received:2019-07-16 Online:2020-02-28 Published:2020-03-06
  • Contact: Xin ZHAO E-mail:zhaoxin_zixi@126.com
  • Supported by:
    国家自然科学基金资助项目(31800499);国家自然科学基金资助项目(31600472)

摘要:

以落叶松木屑为原料,SiO2为孔结构调控剂,采用一步原位掺杂法制备了落叶松基SiO2@C复合材料,探讨了炭化温度、模板剂SiO2对复合材料孔结构及吸附性能的影响。利用扫描电镜(SEM)、透射电镜(TEM)、氮气的吸附/脱附、拉曼光谱、X射线衍射仪(XRD)、傅里叶红外光谱(FT-IR)仪和X射线光电子能谱(XPS)对复合材料进行表征,并以乙基紫染料为模型物研究了复合材料的吸附行为。研究表明:随着炭化温度由700℃升高至900℃,SiO2@C复合材料的形貌由交联的球形形貌转变为网状结构,孔隙结构由整体无序向局部有序转变,比表面积由538 m2/g提高到780 m2/g;经900℃炭化制备的复合材料SiO2@C-900具有较高的比表面积和有序的孔隙结构,对乙基紫染料的吸附值高达378 mg/g,在温度55℃,pH值7的最佳吸附条件下,对乙基紫染料的脱除率达99%;重复利用5次后,脱除率仍在97%以上,说明复合材料稳定性良好。SiO2@C复合材料对染料的吸附符合Langmuir吸附等温模型,吸附动力学符合准二级动力学,即主要是化学吸附。

关键词: 落叶松木屑, SiO2@C复合材料, 原位掺杂, 结构调控, 染料吸附

Abstract:

The porous SiO2@C composites were fabricated via a one-step in situ doping approach using biomass waste larch sawdust as raw material and SiO2 as pore structure regulator. The effects of different carbonization temperature and SiO2 as the template on pore structure and adsorption property of composites were investigated.The SEM, TEM, nitrogen adsorption/desorption, Raman spectroscopy, X-ray diffraction (XRD), Fourier infrared spectroscopy (FT-IR) and X-ray photoelectron spectroscopy (XPS) were adopted to characterize the composite material. Meanwhile, the adsorption behavior of the composites was studied by using ethyl violet dye as the model. The results showed that the morphologies of SiO2@C composites obtained from carbonization between 700 to 900℃ changed from cross-linked spherical to network-like structure, and the porous structures changed from disorder to order.Moreover, the large specific surface areas increased from 538 m2/g to 780 m2/g of the SiO2@C composites.Benefitting from high specific surface area and ordered pore structure, the adsorption value of SiO2@C-900 was as high as 378 mg/g for ethyl violet dye; the removal rate of ethyl violet dye was 99% at the optimal adsorption condition of temperature 55℃ and pH 7, and the removal rate was still above 97% after repeated 5 times, indicating that these composites had good stability. The adsorption isothermal was in line with the Langmuir adsorption isothermal model, and the adsorption kinetics was in line with the second-order kinetic model, namely, which was mainly chemical adsorption.

Key words: larch sawdust, SiO2@C composites, in situ doping, structural control, dye adsorption

中图分类号: