欢迎访问《林产化学与工业》,

林产化学与工业 ›› 2003, Vol. 23 ›› Issue (3): 41-44.

• 研究报告 • 上一篇    下一篇

新型漆酚铁树脂修饰的固体传感器的制备及应用

杨春海, 史伯安   

  1. 湖北民族学院 化学与环境工程学院, 湖北 恩施 445000
  • 收稿日期:2002-12-02 修回日期:1900-01-01 出版日期:2003-09-30 发布日期:2003-09-30

PREPARATION AND APPLICATION OF NOVEL SOLID SENSOR MODIFIED BY POLYMERIC COMPOUND OF URUSHIOL-Fe

YANG Chun-hai, SHI Bo-an   

  1. School of Chemical and Environmental Engineering, Hubei Institute for Nationalities, Enshi 445000, China
  • Received:2002-12-02 Revised:1900-01-01 Online:2003-09-30 Published:2003-09-30

摘要: 研究了一种用漆酚铁树脂进行化学修饰的固体传感器的制备方法,并初步探讨了其提高金属离子测定灵敏度的机理。在HOAc+NaOAc和KNO3混合介质中,该传感器测定铜离子的线性范围为4×10-9mol/L至2.5×10-7mol/L之间,富集20min后铜离子的检出限为8×10-11mol/L。用于实际水样的测定,平均回收率可达99.10%,结果满意。

关键词: 漆酚铁树脂, 固体传感器, 化学修饰

Abstract: Solid sensor modified by urushiol Fe resin was prepared for the determination of trace copper in water.Mechanism of increasing sensitivity has been studied.In 0.1 mol/L KNO3 and HOAc NaOAc solution, peak current is linearly correlated with concentration over the range from 4×10-9 mol/L to 2.5×10-7 mol/L.Detection limit(signal to noise=3) is 8×10-11 mol/L after 20 min accumulation.Using the electrode, Cu2+ in water samples were detected, and average recovery is 99.10%.

Key words: urushiol-Fe resin, solid sensor, chemical modification

中图分类号: